Hello

I have to push a 6P9 Nut, 20mm flute lengths into a D25mm drill hole.
I am not sure how to program it! The tappets should take 0,05mm per stroke, drive in with 15000mm/min feed and drive out in rapid traverse.

When driving out, the tappets should lift out of the grove in X so that it doesn’t get stump.
The grove is 3,5mm deep (x direction) that means when I take 0,05mm per stroke then I have to make 70 strokes to reach the desired depth.

Can anybody explain me how to program that with a Mazatrol?

Really appreciate any kind of help!

Kind regards
Thomas