587,419 active members*
3,472 visitors online*
Register for free
Login

Thread: quick help needed on caps tachus42

Results 1 to 2 of 2
  1. 04-15-2009, 09:50 PM #1
    David Flowers
    David Flowers is offline Registered
    Send a message via AIM to David Flowers
    Join Date
    Feb 2009
    Posts
    16

    quick help needed on caps tachus42

    On the ceramic type caps- is there a +/- side to them and if so how do I identify it on the cap? I know there is a +/- on the dielectric and it is clearly marked.

    can I substitute the .1uf(100n) cap for a 104m ??
    Im here with a hot soldering iron right now.....
    Reply With Quote Reply With Quote
  2. 04-15-2009, 10:27 PM #2
    David Flowers
    David Flowers is offline Registered
    Send a message via AIM to David Flowers
    Join Date
    Feb 2009
    Posts
    16
    ok I lied on the dielectric caps there is hollow bar marking on one side is this the positive side?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Ready To Jump Chopper Board Tachus42/Phil
    By camcam in forum DeskCNC Controller Board
    Replies: 1
    Last Post: 06-26-2008, 01:48 AM
  2. caps-m?
    By gravy in forum Mori Seiki Mills
    Replies: 0
    Last Post: 03-02-2008, 01:12 PM
  3. Tachus42`s chopper board manual?
    By sierra in forum Controller Cards
    Replies: 0
    Last Post: 09-13-2007, 11:35 AM
  4. Help needed quick! Sony Magnescale
    By Cold Fusion in forum Community Club House
    Replies: 2
    Last Post: 12-08-2006, 04:09 PM
  5. Power Supply help NEEDED QUICK
    By Cold Fusion in forum Community Club House
    Replies: 3
    Last Post: 12-09-2005, 05:19 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules