H there
I have made some changes in the old post so my Maho 800 can run as an HMC. The next thing is to do some B axis movement, if possible. Turn 90degree drill a hole, turn 90degree and mill pocket. The control doesn't support G54 - G59 offsets, so this has to be done from the middle of the rotating axis.
Do this need to be in the .pst file, or can this be made in mastercam just to rotate the B axis? I don´t need all 4 axis to move a the same time.
Are there any good training online about planes and indexing, or some books just need to have if I can figure this out.
Or do anyone know where to get a post for an Maho 800 C with Phillips 432 control to a fair price, or do someone have an post they are willing to share?
I can upload the post that I have tomorrow, but it is almost the same as the one in a former thread of mine. I'm away for a festival today, so cant upload before tomorrow when I come home.
Cheers, Daniel