[sctechservice]

Hello,

I'm consulting for a metalworks shop that has a Lagunamatic 250 CNC D40, with the Dynapath Delta 40M controller. The shop doesn't have the correct POST processor to translate the Mastercam (ver X 1.2.183) .NC file to the Dynapath format. Long story short, Mastercam won't provide us with the POST.

Does anyone have a processor that would work?

Any help would be greatly appreciated, thank you! Please PM or call.

David M.
SC Tech Service
949-366-3100

>>>Dynapath, Mastercam, POST Processor, Lagunamatic

[phoodieman]

I'm running a Lagunmatic 3560 with a Delta 40 M controller. PM me and give me an email and I'll send it to you.

Phoodieman

[Ole-Dude]

could I get a copy of you're post for the dynapath?
also a sample program for hole drilling and tapping?
and instructions for manually inputting the program and saving it?

Just got this machine and need short cuts to getting it productable

[email protected]

[mburns]

I'm running a Lagunmatic 3560 with a Delta 40 M controller. PM me and give me an email and I'll send it to you.

Phoodieman

I am a high school teacher, we were donated a VMC with a dynapath 30M controller. Would the 40M post processor work for the 30M? I have X4

Mike

[sctechservice]

I am a high school teacher, we were donated a VMC with a dynapath 30M controller. Would the 40M post processor work for the 30M? I have X4

Mike

hello, this is a 5 year old thread - I don't have any post files any longer, it was a project i worked on in 2010. also, i was just the IT provider to a shop with the machine - I'm not familiar with machine operation either. sorry I couldn't help.