Originally Posted by
firepong
So, I think I am going to change to the DYN2 drives with a 750 motor. Honestly don't know if I want to run the DYN4 servo's at 120v. Was going to use either a 1000w or 1500w toroidal 70v power supply to power the 3 motor's. 14A on the 1000w and 22A on the 1500w.In the opinion of the member's here, if I go this route, should I get the 1000w or 1500w?
Also, with the 70v, I am hoping to get the most out of the motor. And in the future, when and if I decide to install 220/240v in the home shop, I can buy the DYN4 drivers (As well as the cables) and be plug and play with the current setup.