IN the directions for the 540 it says to set mach 3 to 2 rev per second and turn the trim pot on the 540. How do I set mach 3 to run my motors to 2 revs per second?
IN the directions for the 540 it says to set mach 3 to 2 rev per second and turn the trim pot on the 540. How do I set mach 3 to run my motors to 2 revs per second?
Figure out what feedrate your machine travels at 120rpm motor speed and move at that feedrate.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)