hi guys,
Owned mori seiki lathe. wanted to utilise cam software but did not know which one. seen alphacam software run on excel mill centre (fanuc controller) & look impressive. pls advice any other cam software suitable for my mori.
hi guys,
Owned mori seiki lathe. wanted to utilise cam software but did not know which one. seen alphacam software run on excel mill centre (fanuc controller) & look impressive. pls advice any other cam software suitable for my mori.
If it's a Fanuc control, pretty much anything will work. You may have to edit simple Mcodes for chuck open/close etc., however a lot of cam programs were kind of built around Mori's from what i've seen. In fact a lot of builders kind of copied a lot of what Mori does.