[TJBishop]

Greetings All
I Will be as brief as possible . First the moric seems to be similar to the O type fanuc on our matsura mill.The memory in this machine was lost do to improper battery replacement. I cleared the parity errors and have reloaded the parameters . However my manual says that there are some diagnostic parameters which I must load and I cannot seem to get my control to take them .The soft keys work and the control panel lights but I cannot get the lathe to move from MDI . My turret shows #1 as being active but the machine is at station 7. I am also receiving the following errors after boot up

071 BP/S
EX 451
EX 098

1.Can someone please tell me how to load those diagnostic parameters?
2.Can anyone explain those errors and how to rid myself of them ?
I am sure once those errors are cleared I will be able to index my turret to the proper location and get my lathe functional again.
Any help In these matters will be much appreciated.
Thanks TJ

[v.sundermoorthy]

hey I may be able to help you but have you solved the problem or not I am not sure.