Hi all,
I recently bought a Doosan DNM 500 with a Fanuc i series controller. I need to drip feed a large 3D milling program from my memory card and haven't had much luck.
I have set up a few older style fanuc's with RS232 drip feeding but have yet to connect this machine to our computer, probably going to try the ethernet connection.
Anyway, I was wondering if there are any specific parameters to set up to drip feed from the memory card. I can copy smaller programs to the hard drive without issues, just can't get it to run on tape mode as I would on an older machine.
Any tips would be really helpful, just need to get this part off the machine asap.
Thanks, Jimmy