Hello, I have a R2E4 series 1 Boss 10 Bridgeport that was working fine for awhile, but now when I turn it on, all the lights on the FMDC and the BSP boards light up, with no blinking. Also all the lights on the controller are lit up, I remember when she was working, not all the lights would come on. We called in a Bridgeport Rep, paid him $500 to take out the boards and reseat some chips, then it worked for 7 hours, then it went tits up again. My CRT doesn't show up either, so I can't see any faults. The light on the EAF does not come on either, so it must be before that. It acts like it is in a reset mode that never does anything. I took out the FMDC, EZIO, and the BSP boards and cleaned them, and pushed on all the chips. but is still doesn't work, can anyone help me please??
Brian
Thread: She was working
Results 1 to 2 of 2
-
07-25-2005, 08:13 PM #1
Registered
- Join Date
- Apr 2005
- Posts
- 53
She was working
-
07-26-2005, 03:39 AM #2
Moderator
- Join Date
- Nov 2004
- Posts
- 3028
Check the power supply. If it is out of spec, it will not work.
George(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With Quote
Posting Permissions
