Hi
recently I have got the 109 error on machine I rest the drive unit in machine cabin but again it will come and the machine stops .please help me
Hi
recently I have got the 109 error on machine I rest the drive unit in machine cabin but again it will come and the machine stops .please help me
H?
WE CAN REPAIR THE DRIVER I CAN HELP YOU
THANKS
Thanks for the answer
It gets the OL Alarm or OC alarm . I reset the drive and clear the fault but the machine gets the alarm more than 10 times in a day .
can you tell me please alarm led on driver
VAC D11 UN?T ?
A technician check the drive and its OK . I suspect about the spindle encoder because I plug out the cable of that and agian plug in so the errors increased I don't know what to do
I can help you with the repair your convenience problem will be solved please contact me
please check your massage box
My email
[email protected]
Phone number is not correct. Opscontrol
hi
?,m whatsapp
https://wa.me/905308484856
Motor not shorted transistors are OK.
We changed some capacitors on spindle driver board now the only alarm is OC
OC usually means overcurrent. So indicates a short or transistor fault.
One time I had an Okuma motor fault where there was a motor connector insulator fault, the crack was between the two thermistor pins and the motor phase pins, power tracked and caused an OC fault and axis noise. Okuma supplied new motor plug and cable connectors, no fault after replacement.
my milling C.N.C machine had lose ALL PARMETERS , IF possible send to me the parmeters( bridgeport vmc 500 with heidenhain tnc 370 cnc control) Tank tou ,
Thanks everyone the problem has been solved