I hope it's OK to post this here, I couldn't seem to find a good catagory. Move it if needed, just tell me where it went!
I bought a CNC router that was nearly complete. It had been used some, but the wires were all free to roam. I added wire carriers and it's all nice and neat now, BUT, I thought of the bright idea of adding an extention cord through the wire carriers to power the router motor. Now I'm having second thoughts before I use it. The motor wires for the X and Z go through the carriers along with the extention cord for 110V. Might I encounter a problem? If so, what problems? I just don't want to cause smoke. What do you do with the power cord for the router?
Thanks for any input!
Fred