We all love to see great routers and machine projects, but if you're like me, you neglect to smaller elememts that go on such machines.
It is about time for me to make a dust collection system for my machine.
Up until now I have just been vacuuming up after each job.
During the weekily shopping I have gone down the cleaning product section and noticed the cheap dustpan brushes. About 2 dollars each. I have thought if I bought 4 of them and cut off the handles, I could then screw them to a piece of MDF to form a square.
I would then cut two hole in the mdf, one for the router bit and the other for the vacuum. The other addition to this project I was thinking about was to have an air stream that was aimed at the router bit. That way it would help to cool the tip and also stir up the cut particals so they could be sucked up easier.
I will post some highly stimulating pictures once I have built this project. Please dont hassle me for these pictures any sooner, since i dont want to rush this project and get it wrong.
Does anyone have any suggestions b4 i actually get started?