7' x 3.5'
Door slides straight up.
Coolant collects in center, mill will be lifted 1" off the pan to get out of the fluid.
Plastic is just light weight plexiglass
The door will be on a track
The pan under the mill I plan on using 1/16 aluminum.
Any suggestions greatly appreciated, I saw the other enclosure thread gots some ideas from it.
I am planning on upgrading to the 3hp motor. I want to get the max speed possible should I be shooting for 2000 gallon per minute pump?? Any advise appreciated.
I was looking around Enco did not see any high output flood kits, how much should a good kit go for any links sources thanks