less than 10 IPM (4.2mm/s)
10-50 IPM (4.2 - 21 mm/s)
50-100 IPM (21-42 mm/s)
100 - 300 IPM (42 - 127 mm/s)
300 - 600 IPM (127 - 254 mm/s
faster than 600 IPM (254 mm/s)
Exactly. On the other hand, high acceleration is probably more important during cutting than high speed. If you have a lot of short moves the machine is never up at top speed, so acceleration gives more benefit than top speed. That's also a reason why I backed off from 10,000mm/min to 8,000mm/min. No point in higher speed on my small machine unless I can considerably increase acceleration also.