Hey guys,
Total noob here. I just finished building and calibrating my machine and need to make a lathe chuck adapter with a circular bolt pattern. Its a disk of mild steel 5" in diameter and I need to drill 3 holes to mount it to the chuck.
Lets say I need to make a 3-hole circular bolt pattern 3.5" across with a .5" drill bit. The holes will be .5" deep.
How would I enter this into the wizard? I may be able to ape my way through it but am afraid of breaking something since this is unscheduled and I have not yet installed my limiting switches on the mill.
Thanks!