[Brian FRF]

My paper says 2600. Alos tried 2500, 5000, no luck. Machine is trying to rapid at 400ipm, thus causing an e-stop. runs fine in rapid at 50% override. Ideas?

The parameter list I have is from Milltronics, listed by serial#. About to keep trying random numbers until something works!

Its parameter #18 if that help, and cent 4/partner 5 machine

[Ben Colby]

Parameter # 18 for Centurion IV control, 0000 = 200 IPM

[Brian FRF]

This forum is great. I post up problems, and then 1/2 the time find the answer myself! But before I post, nothing works... its like repairing machines through osmosis!

At any rate, missing parameters from the supplied milltronics sheet, 37, 38, 39 all needed 2000 put in place, for 200ipm max speeds. 2600 stays in #18, though I dont think it actually matters on this particular machine.

Hopefully helps someone in the future. I just happened across another parameter list in my fat notebook/manual/binder thing that came with this machine!

[Brian FRF]

Parameter # 18 for Centurion IV control, 0000 = 200 IPM

FWIW, tried that one too. No dice, see my other post for what did work, tho. But thanks, Im sure it works on some!