I am building my cnc router and am just wondering if what I have will do the job that I want. I have the xylotek 3 axis kit, and have a table that is roughly 60" x 30". I will be using the table almost exclusively to cut acrylic in the .25" to .375" range. The table uses a belt system on the X axis (60") that does not use any sort of reduction in the belt system. The rails are 20mm hard steel with dual pillow block on each rail. the y and x axis are both 12mm hard steel with flanged bearings for the guides. The tables frame is all 2x4 wood. All is driven by 1/2 x 10 acme screw. The spindle will be a porter cable trim router. Will this table have the strength to handle a full size router spindle? IPM is not a concern as long as it does the job. I am more concerned about accuracy rather than speed but what do you think a reasonable IPM will be?
Thanks