587,087 active members*
2,850 visitors online*
Register for free
Login

Thread: Hitachi Seiki VA 35 mill w/ 6m fanuc

Results 1 to 1 of 1
  1. 12-27-2013, 05:28 PM #1
    rdstillw
    rdstillw is offline Registered
    Join Date
    Dec 2007
    Posts
    8

    Hitachi Seiki VA 35 mill w/ 6m fanuc

    I am posting this in regards to this old machine and I had a question for you. I was wondering if there was any way to feed this machine through the serial port the g-code? The machine itself has limited space capacity to hold larger machine codes and even has a old tape drive. Do you know of any solution around this limitation besides junking it and getting another machine.

    Regards,
    Rich
    Attached Thumbnails Attached Thumbnails IMG_1977.jpg  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Hitachi Seiki 4NE-600 w/ Fanuc 5T issues
    By wiretekaaron in forum Fanuc
    Replies: 3
    Last Post: 06-23-2019, 08:57 PM
  2. Fanuc 5T Hitachi Seiki Parameters
    By TechnoJunkman in forum Fanuc
    Replies: 11
    Last Post: 02-17-2011, 12:43 PM
  3. Hitachi Seiki w/ Fanuc 18 C
    By jumpstart in forum Uncategorised MetalWorking Machines
    Replies: 0
    Last Post: 03-16-2010, 09:20 PM
  4. Hitachi Seiki Fanuc 11M Parameters
    By diegojulio in forum Vertical Mill, Lathe Project Log
    Replies: 0
    Last Post: 03-03-2009, 12:33 AM
  5. HITACHI SEIKI / Fanuc 11m
    By mn12mike in forum Fanuc
    Replies: 2
    Last Post: 12-14-2008, 06:06 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules