[techscan]

My Might Comet with a Meldas 520m control runs fine with one exception. After each movement whether its a lead in, an arc, a line or a lead out, the machine pauses for a moment before executing the next move. It is not in the post processor or the actual code as I use both on another machine and it works fine. Is there a setting in the controller to eliminate this. Any help would be appreciated.
Thanks

[dblox]

G09 = Exact stop check
G61 = Exact stop check mode
G61.1 = High-precision control mode
G62 = Automatic corner override

All of those will cause the machine to "pause" between moves.

G64 = cutting mode

This will cancel any of the above modes (I think).

Check this:
Press Tool/Param, press Control, check "switch" 34 is off. This is G61.1 on by default. Turning it off will enable G64 by default instead.