Originally Posted by
big_mak
I was waiting for an answer from you Geoff. I was thinkning something in the SL-10-20 Range. It will be for production Stuff eventually. Like I said I don't want to do stuff that requires a crane to load the machine. Smaller end. At the same time something flexable enough for a job shop environment.
I've seen your setup, and your barfeeders. Slick!!!! Have they proved reliable? I've not heard much good about the Haas Supplied barfeeders.
I'm looking for comparisons between the brands. I know Hurco is new to lathes. And there are a few guys out there with Femco machines. Just looking for opinions.
I'm happy with the VF-3 I got just less than a year ago. The only issues I've had were software related, and that's to be expected with a new version of the control. Just wish they'd speed up the refresh rate!!!!! Drives me a bit bonkers sometimes.
Software issues set aside you already have a HAAS so why not stick with them. You already have experience with their controls too. If you need a better machine go with the Hardinge Talent or Quest.
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com