588,687 active members*
5,693 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Stepper Motors / Drives > Pacific Scientific 6510 Drive

Thread: Pacific Scientific 6510 Drive

Results 1 to 2 of 2
  1. 03-29-2006, 07:45 AM #1
    marshall1
    marshall1 is offline Registered
    Join Date
    Dec 2004
    Posts
    6

    Pacific Scientific 6510 Drive

    Can anyone tell me why there is a Step +, Dir +, Enable +, and Step -, Dir -, Enable - on this drive? I have 3 of these drives and would like to connect them to a CNC4PC Parallel BOB Board. Any ideas would be greatly appreciated.
    Attached Thumbnails Attached Thumbnails 6510.jpg  
    Reply With Quote Reply With Quote
  2. 03-29-2006, 10:27 AM #2
    jeffs555
    jeffs555 is offline Registered
    Join Date
    Jun 2004
    Posts
    463
    Opto-isolated inputs. Read the manual for how to connect. http://www.pacsci.com/support/docume...s/ma6410rv.pdf
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules