I am experimenting with a PCB creation program called PCB wizard.
It only exports the gcode out as Gerber.
How do I change this code so that I can use it in Mach2 and cut the Circuit board paths?
I am experimenting with a PCB creation program called PCB wizard.
It only exports the gcode out as Gerber.
How do I change this code so that I can use it in Mach2 and cut the Circuit board paths?
Being outside the square !!!
Get the demo copy of Kellyware KCAM software at http://www.kellyware.com/kcam/index.htm
Import the gerber file, KCAM will produce the GCode for you.
Stupid questions make me smarter...
See how smart I've become at www.9w2bsr.com ;-P