I have a Mitsubishi MTC10B Lathe with the Meldas 325LVG control. Trying to loop a program to work with a bar puller. M97 Does not seem to work and I don't see anything in the manuals I have. Any help would be appreciated.
I have a Mitsubishi MTC10B Lathe with the Meldas 325LVG control. Trying to loop a program to work with a bar puller. M97 Does not seem to work and I don't see anything in the manuals I have. Any help would be appreciated.
Have you got a target block labelled and in the subprogram?
I.e.
M97 P500
----
----
M30
----
----
N500
----
----
M99
In this example, M97 P500 causes jump over blocks and M30 to N500 block and M99 is end of subroutine back into the main program ended with M30. (---- are blocks of program code)