[mactec54]

Hi dream...i didnt see ur post until after i messed eith mach 3 ...but i think i figure it out...i move each axis to max neg travel...i then hit ref all home...then in soft limits i enter +7 for x ...+4 for y ...+6 for z...and put 0 in all - fields.

And mske sure persistent DRO is checked in gen config.

Now my mach coord soft limits are set and mach3 remembers every time i open n close mach3 ...i dont have to repeat this.

I tested it and worked great and will be a good safety feature on my one romaxx cnc that uses v wheels and has no hard stops...this should prevent any user error and having gantry roll off the rail....which would not be a good thing

Thank you for the awesome great info...

No It will never remember where Home is without a referance to home position on start up