Originally Posted by
craig00747
Hello SteveThank you for your response. We have a TIME ZONE difference here in SA.Okay, I just learned that my AKZ250 motion controller does not support a "slave channel". I am not using the Arduino UNO type controller, which was supplied in this kit. Their wiring diagram shows two NEMA 23 motor, wired to one DQ542MA stepper driver. Nothing actually done to show that both of these NEMA 23 stepper motors, are wired independently. So I assume that it will work?I have a Registered version of MACH3 and the program recognises the AKZ250 board - like plug and play. There was however one file, which I had to copy and paste into the MACH3 Directory.Please explain what plug-in you refer to?RegardsCraig