I have a DIY CNC router table that was built a while ago by someone else. I am using LinuxCNC to control it and the gmoccapy interface. Basically a few days ago was my first introduction to this device and I am super excited. Worked out how to import my 3D model into Fusion 360 and generate the G Code. The machine moves around and follows the steps but doesn’t turn the router on unless I do it manually in the software. But it stops as soon as I hit play.
If I put M3 on a line in the G Code the router switches it on and the program proceeds but the machine doesn’t move.
If I take out the M3 the router doesn’t turn on and the program proceeds and the machine moves.
I can just plug the router directly into a power point to force it on all the time but I know this isn’t how it is meant to work and am also concerned that it won’t allow it to switch off with the eStop.
I figure the problem might have arisen from playing around with the conf wizard as I didn’t understand it all a few days ago when I first jumped in there. Always my problem with new gadgets (as I am sure many can relate lol).
Does anyone know what would result in the problem I am facing and can anyone point me in the right direction? Any and all help is greatly appreciated.