CNCnUtZ, to set the View look in the lower left hand corner of the screen were it shows (Cplan) this were you want in most cases a D+ or D- by the upper turret or muns being a lower turret thoghts.
Now when you say create a line horz give it the Dia value and it will place it by half the dia in the D+ being Y+ on the screen or the oppist.
this just a start. I will be back.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .