Was looking at the Hoss-stuff, and that motor/driver place up in Chicagoland, and there -is- a servo combination listed... It's a little more expensive, but hey, given the time involved, I'm wondering if it may prove easier to mess with in the long run... This machine is primarily going to be used to machine stuff like stressproof and 1045, but probably some small tool steel parts too...

I've got mounts more or less together, getting ready to order electronics. Looking to go four axis too... I'm probably going to "cage" the machine in some I-beams too when I make the permanent stand, just to boost rigidity.