588,156 active members*
5,111 visitors online*
Register for free
Login

Thread: Lathe geometry offset

Results 1 to 3 of 3
  1. 01-23-2007, 08:53 PM #1
    cncdigger
    cncdigger is offline Member
    Join Date
    Jan 2007
    Posts
    22

    Question Lathe geometry offset

    Have anyone heard of an X tool offset entered in the register as a radial value, or is it always diametral?
    Reply With Quote Reply With Quote
  2. 01-23-2007, 11:28 PM #2
    HuFlungDung's Avatar
    HuFlungDung
    HuFlungDung is offline Moderator
    Join Date
    Mar 2003
    Posts
    4826
    Sure, it could be either way, depending on the make of the controller.
    First you get good, then you get fast. Then grouchiness sets in.

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
  3. 01-29-2007, 11:52 PM #3
    cncdigger
    cncdigger is offline Member
    Join Date
    Jan 2007
    Posts
    22
    Thank you for the info.

    Alain
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. FANUC 3M G54 OFFSET, H-OFFSET----Please help!!!
    By cjchands in forum Fanuc
    Replies: 2
    Last Post: 05-25-2009, 05:22 PM
  2. Dimensions on 2D geometry
    By mayhugh1 in forum SprutCAM
    Replies: 3
    Last Post: 10-26-2006, 05:02 AM
  3. Geometry from NC
    By rherman in forum BobCad-Cam
    Replies: 2
    Last Post: 09-21-2006, 01:10 PM
  4. rusty geometry
    By bdrmachine in forum MetalWork Discussion
    Replies: 1
    Last Post: 07-16-2006, 09:34 PM
  5. Anyone tried the 2D geometry tools?
    By S4 Monster in forum SprutCAM
    Replies: 0
    Last Post: 02-02-2004, 08:09 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules