Has anyone go this working with a YL620-A?
Baud Rate to 19200 as per the current VFD setting / one stop bit, and changed the VFD address to 1
On the modbus Setup i have the following
On/Off address coil 0016. -- Not correct see above
Frequency Address coil 0000-- Not correct see above
Spindle on CW 0000-- Not correct see above
Spindle on CCW 0001-- Not correct see above
Spindle Off 0003-- Not correct see above
Check box for multiple coils - Not sure what this should be but I tried other combinations
The link to the manual is here, a bit chinglish
https://bulkman3d.com/wp-content/upl...ter-Manual.pdf