Re: Mach 3 Homing the wrong way
I have all my limits and homing on the same pin and it works fine. All my switches are NC and wired in series. When the Homing sequence is started, Z goes to the top and hits the switch and backs away until its cleared, then X and then Y. When the machine is in the running mode the switches are now Limits. Works like a charm, I think it worked the same on Mach3 but its been a while and I'm on Mach4 now.
Retired Master Electrician, HVAC/R Commercial. FLA Saturn 2 4x4 CNC Router Mach4 Kimber 1911 45ACP