[The CNC Noob]

I have been a manual machinist for 8 years and now have the chance to move onto a haas hs1 if I can catch on quickly, but I need help. Can someone give me a walk through of a part setup on this mill? All tools and program loaded already. Mainly just setting the offsets and touching off with the tools. And maybe a explanation of the offsets and exactly what each one is such as the workpiece offset. Thanks to anyone who will take the time to help me out.

[Donkey Hotey]

It would take writing a book here, to tell you everything you're asking. The manuals are available for download, right on their site:

http://haascnc.com/custserv_updates....erator_manuals

[The CNC Noob]

Thanks I found all that I needed to know there.

[DSL PWR]

Thanks I found all that I needed to know there.

All that you found there was a good start...

Good luck, and I hope your 1st crash is only minor...

On mine I took out a $300 tool, so it wasn't too bad.

[The CNC Noob]

Yeah maybe my first wont be to expensive. At least my first few jobs are on delrin which should be more forgiving.

[extanker59]

Tell that to my formerly pristine vise with a nice hole in it. Running plastic (forgiving), ran the endmill right through it into the vise.
Don't let them rattle you -- "now have the chance to move onto a haas hs1 IF I can catch on quickly". My caps.