Re: OKUMA 1181-11 MCS DIFF OVER X AXIS ERROR
If you can move the x and have no issues when driving it with the Z drive, then based on your description you have either a bad X cable or X drive unit. I would guess that you can no longer move x because you have exceeded the X limits when you tried moving it with the z drive. The motor has an absolute encoder so it will keep the position even after disconnecting it. Use the PR Zero offset in system parameters to get the position back between your limits. You probably see either overflow or a number outside of your limits on your X display I’m guessing?
Best regards,
Experience is what you get just after you needed it.