588,585 active members*
12,558 visitors online*
Register for free
Login

Thread: Questions about the IH Mill CNC Conversion

Results 1 to 2 of 2
  1. 05-12-2006, 06:49 PM #1
    Bird_E
    Bird_E is offline Registered
    Join Date
    Mar 2004
    Posts
    115

    Question Questions about the IH Mill CNC Conversion

    Can anyone answer a few questions I have about the IH Mill CNC Conversion?

    1. On the Z Axis, does the ball screw get supported on the lower end? If so does it use the exsisting bearing from the original hand crank assembly?

    2. Does anyone know what kind (manufacture) of servo motors the CNC conversion uses?

    3. What is the belt reduction ratio for the X Y & Z?

    4. I'm REALLY interested in plans or a kit for the BELT Drive conversion. Has anyone seen this yet?

    Thanks in advance!
    Bob
    Reply With Quote Reply With Quote
  2. 05-15-2006, 05:11 PM #2
    KEYTEEM
    KEYTEEM is offline Registered
    Send a message via Yahoo to KEYTEEM
    Join Date
    Jan 2005
    Posts
    126
    did you see whats available from aaron at industrial hobbies?
    he sells kits - i don't think he sells plans
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules