Today I spent a lot of time cross checking pins & ports in UCCNC and validating wiring to the UB1. Robert (whose build mine is based on) joined me on the phone a few times and the net result is that the machine still won't jog. One error we discovered was that the VFD needed to be programmed and reporting a ready condition before we get a full enable signal. We bypassed that and now the status is as follows:
1) Power on the controller - OK
2) Launch UCCNC - UB1 recognized and various status lights come on
3) Hit hardware reset button - Motors power up and lights go green - UCCNC reset button flashing
4) Hit software reset button - Motors go yellow and enable lights on the UB1 go out.
We tried checking Axis Enable low & off for all axes, which creates the following condition - motors green and UCCNC stuck in a loop with flashing reset button and an error message every time you push the reset button.
Not sure where to go from here. All ideas welcome.
Robb