[pminmo]

Does somebody have the software and a little time that could build a mill file for this pcb :

http://webpages.charter.net/pminmo/minimlchannel.bmp

(600dpi)

It part of the open source project a little higher level view:

http://webpages.charter.net/pminmo/cncelectronics.htm

Phil

[tpworks]

Phil,
What size end mill are you going to use?
Tom

[pminmo]

Tom,
I'm not plannong on using it. Would just like to post a file so that it is available for people who might like to build a board. .020 to .010?

Phil

[vladdy]

left a message in another area, but anyways..
If you have Eagle, just us one of the outline to gcode converion ulp's..
easy to do, especially if the end user has a 60 degree 'tree' cutter in the dremel..
or were you looking for full removal of unneccesary copper?

I use 4.08r2 and some of the ulp's right off the cadsoft site..

enjoy..

[pminmo]

vladdy,
I tried the ulp route, at least the one I tried basically rasterized the file an removed unecessary copper, I was looking for simple path isolation. Tom sent me a file.

Thanks,
Phil