FYI - Tormach has confirmed a RapidTurn bug in PP 2.0 in which it wont execute programs. Its very similar to the spindle sensor issue in its symptoms.
No ETA and I dont have any more information than that. Just letting you RT people know.
FYI - Tormach has confirmed a RapidTurn bug in PP 2.0 in which it wont execute programs. Its very similar to the spindle sensor issue in its symptoms.
No ETA and I dont have any more information than that. Just letting you RT people know.
Tormach PCNC 1100 Series 3 w/ Rapid Turn, Fusion 360
Crap I guess I can delete my other thread this just bit me. I mounted my rapidturn, fired up a parting operation. It hit's g30 runs over z until it hits the right spot, spindle fires up and it halts right there.
According to the release notes it does.
Fixed IssuesAll Machinesl Some files are not correctly recognized as G-code, and the File tab will not load them. (PP-1887)Millsl Resolved a RapidTurn® pausing issue when using G-codes dependent on spindle speed sensing.Lathel Resolved a rare G96 arc blend following error.
Tormach PCNC 1100 Series 3 w/ Rapid Turn, Fusion 360