[kulibin]

Hello. At Me milling cutter HURCO BMC-25 CNC Ultimax 2. Have by transportation disconnected the panel of the operator, and wires of a food have not noted. All wires of black colour, that where is not clear. On wires +5, +12,-12, +24 Prompt that is connected on plugs TB52, TB54.

[bloke]

The wires may be all black but they have numbers on them. put them in the connector on the back centre of the board matching the numbers up.

[kulibin]

[QUOTE=bloke;741671]The wires may be all black but they have numbers on them. put them in the connector on the back centre of the board matching the numbers up.[/QUOTE
Unfortunately marks on wires are not present.I Have measured pressure of a food on these wires. I have already found where is connected +5, +24. I do not know where to connect +12volt,-12volt

[bloke]

from left to right:
0v
+24v
0v
0v
-12v
+12v
+5v
+5v

[kulibin]

from left to right:
0v
+24v
0v
0v
-12v
+12v
+5v
+5v

Thank you very much. the Panel of the operator has earned. You know than differs CNC Ultimax from Ultimax2. By sight, they identical. At Me Ultimax. Best Regards.

[kulibin]

Hello You helped me, HURCO, thank you. I have more questions. I put an extra (Dual axis board). The menu appeared (5 axis present) but I do not see the values ​​of the coordinates of A, B. Advise where you can get Service manuals and shematic diagram HURCO BMC25, Ultimax2, CRP2. The value of first name and parameters. I want to connect additional A, B, axis. Best regards. ([email protected])