Greetings all,
I'm not sure if I'm in the right section-so here it goes- I recently purchased the imach pro pendant/card from vistacnc (works good) and installed the screenset. all works as should but i lost the xzy centering/probe height ability. I called vistacnc and they dont have any modifications for screenset. My question is- does anybody have a mod in the works for this? If so, where?
I am only a user , not a designer/programmer so any help is great. I got my original mach blue screenset from this forum (thanks again erniebro) and was happy until this new addition.

Thanks for any help,

Gadget