Need Help Please! I connected my pc to the plasma table, and turned on Mach3 but I cant get anything to happen the estop doesn't register on the pc and mach wont move the motor Is the pci parralel port address set up correctly in "mach"?
I dont use the motherboard parallel port (is almost always 378 hex shown in MACH as 0X378) but an expansion PCI port (IEEE1284 Mecer). The only things installed on this pc are widows XP and mach3 no antivirus and windows updates are off. I went into the bios and changed to Enabled from auto, and changed to the EPP port setting for the parrallel port.In Device Manager the address are [0000D000-0000D007] [0000D001-0000D107] [0000D002-0000D207] [0000D003-0000D307] is that correct? i need some advice please if there is anything more to set up or check on mach let me know.