Hello all,
I'e build a solsylva machine 25x25inch and I was wondering if there a way to compensate flatness on Z from mach3 for example ?
Here is a shematic of my flatness. I"d like to have a virtually z=0 everywhere :
Thanks !
Hello all,
I'e build a solsylva machine 25x25inch and I was wondering if there a way to compensate flatness on Z from mach3 for example ?
Here is a shematic of my flatness. I"d like to have a virtually z=0 everywhere :
Thanks !
Use the machine to route the table flat.
There's no way to have Mach3 compensate for it.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
ok thanks you, I will make a flat table
regards