Hello everyone. Although I've been signed up for awhile this is the first time I managed to get on and post.
I'm considering buying a King Canada Industrial Knee Mill. The model number is 942vs-6-nf and It's a single phase 220 volt machine. I don't have three phase in my shop so I'm limited to what I can get.
The mill comes with an installed DRO by FAGOR. It will have a table power feed, 18 PC collet set and a K-type 6" vice.
I was wondering if anyone here had any experience with this type of Mill and King Canada for that matter. I'm betting it's a Chinese machine and if it is, is it any good? The price on this mill is right on $10000. Any info would be greatly appreciated. Thanks!
Here's a link to the machine: http://www.kingcanada.com/Products.htm?CD=36&ID=161