Originally Posted by
ALC4CNC
Hi Guys
Still trying to correct this machine. w 10T control
I think the original error might have been cleared when I reconnected the Encoder connector on the Spindle but I have not been able to RESET the displayed errors.
I only see one RESET button on the control panel at the Keypad.
I find no other reset except for the EM STOP mushroom button.
it is possible that the RESET button is bad but unlikely since it is rarely used.
I am not familiar with Fanucs, Does anyone know how to reset this machine?
like Master reset, Hold certain button while power up, combination of buttons, etc.
Also I am hoping someone might have a PDF version of manual or sections of
This machine has an Encoder on the spindle and no other sensors.
and driven by belts from Gearbox mounted below. Gear box only has
the LO-HI Gear position sensors on it
Would appreciate any help on this.
Thanks
AL
Originally Posted by fanucman
" its in estop because you are getting a spindle alarm.. when the alarm is displayed what doe the spindle amp show on the display?"
Hey Fanuc.
They Spindle Amp itself doesn't have any display or LEDs of any sort.
too Old? A20B-0009-053 I think the board says.
but the other 2 amps do have a bar-graph type of LED array.
(all off)
the Motherboard does have a "1" on the 1 Digit display
BTW the CRT display:
SVE30 Emerg. stop
OT100 Spindle Alarm.
the ALM keeps flashing on CRT
As far as I can tell the Spindle doesn't have any sensors other than the encoder, (maybe pressure for the Chuck but that doesn't have to be on the spindle.)
When we first fired up the mach. and the alarms came on we found the Encoder disconnected. Pwr down, reconnect, and alm still there.
maybe I just don't know HOW to reset.
Thanks.
AL