[alexbelen7]

guys need help on this one...Fanuc series 0-C controls...

Activities done:
1. replaced cable of servo motor to servo amp
2. replaced servo motor
3. replaced servo amp
4. replaced linear scale
5. replaced axis board
6. replaced memory board
7. checked also stiffness in ballscrew while motor is not installed...seems ok

Alarm still shows up after this activities...i've ran out of ideas...please advice!

[stevo1]

How about the encoder cable.

I am really just throwing it out there but on one of my VMC's i kept getting disconnect but it was pulsecoder disconnect. I replaced the cable and all is well.

Stevo

[alexbelen7]

yup I already that, I just forgot to include it in my list...

[not an expert]

Turn the scale off?
One that not listed is the backplane but don't think that would cause it.
Does it happen when you move or just at power up?

[alexbelen7]

no I didn't turn-off the scale I just replaced the cable of the scale and still I'm encountering the same problem...this alarm shows up anytime...moving or not, alarm shows up...I experienced powering on the machine and homing it's axes' and left it for a couple of hours due to other activities and when I came back the alarm already shown up.

[harshh]

hii sir i face same alarm form last 6 days in ge fanuc control 416 alarm came after axis moving 1) i change linear scale feedback cable but problem is still .2)i bypass the linear scale of same axis then checked it is ok thats means its not a servo mtor and rotory encoder problem but accuracy problem came so please help me

[harshh]

hii sir i face same alarm form last 6 days in ge fanuc control 416 alarm came after axis moving 1) i change linear scale feedback cable but problem is still .2)i bypass the linear scale of same axis then checked it is ok thats means its not a servo mtor and rotory encoder problem but accuracy problem came so please help me