[romasx]

Thank you phucrobusl and memoryman very much. Received Base0 board after vacation, changed it and system booted. Only had blown transformer, two automatic fuses and one servo ... Now there left to repair the servo

[romasx]

Hello again, maybe someone has Fanuc servo amplifier schematic/service manual? Board A20B-1003-0090/2. As I understand there is a problem with DC voltage detection after shortening of phases in transformer. DC error Even at much lower supply voltage braking resistor is often turned ON and overheating switching transistor. Suspecting DV46.

Regards
Romas

[Adnan007]

i have alarm problem Murata c3000

1013 IN PUNCH CYCLE

[9xpro02]

Okay how nice!! It is the B-61213E-2/01 FS15A Connecting manual (BMI Interface) 1988 that i need.
I will gladly pay for this, where should i turn?

HELLO BRO.
DID YOU GOT IT?
CAN YOU SHARE WITH ME?

I AM VERY GRATEFUL FOR YOUR SUPPORT.
BEST REGARDS.

[RicardoEV]

The oldest Fanuc 15 control is a A, which is what you have. I have all manuals, most are scanned.
Have you turned the control ON while holding the '7' and '9' keys?

Hello Memoryman.
A few years ago, I bought 3 used machines with Fanuc 15A controls and I don't have a single manual for that cnc. I want to ask you if you can provide me or sell me the scanned maintenance and operation manual for this cnc?

[phucrobusl]

Hello Memoryman.
A few years ago, I bought 3 used machines with Fanuc 15A controls and I don't have a single manual for that cnc. I want to ask you if you can provide me or sell me the scanned maintenance and operation manual for this cnc?

P.m me [email protected]