I am very new to this programming. Is there a simple program to face the barstock, feed out a length of 1.25, then cut it off without using the back pickoff. (The barstock is .142 in dia.) Thanks for your help!!
I am very new to this programming. Is there a simple program to face the barstock, feed out a length of 1.25, then cut it off without using the back pickoff. (The barstock is .142 in dia.) Thanks for your help!!
Use right hand tool for cut off - small bar
O1(NEW-PART)
$1
M9
G50 Z-.004(FACING AMOUNT - SAME VALUE AT END)
M6
/M52
G18 G97 G40 G113
M86 M90 M96 M119
G0 G99 X0.17 Z-0.025
G820
(FACE OFF)
M3 S1=2500
T303
G0 X0.17 Z.05
G1X.143F.002
Z0,C.02(C=SIZE OF CHAMFER)
X-0.05
G0 Z-0.025
G0 G40 X.17 Z-0.025 T0
(CUT OFF)
M3 S1=2500
T101 H1.5
G0 X0.17 Z[1.25+SIZE OF TIP]
G1 G99 X-0.05 F0.002
(BAR CHANGE)
M8
/M98 P**
M9
M5
M7
G4 U1.0
G0 X-0.05 Z-0.004 T0
M6
M56
M2
M99
$2
G820
M2
M99
$0
A
#814=0000001420
#815=0000000500
#816=0000001000
#817=0002500000
#822=0000000020
#824=-000000500
#818=0000017500
#819=0000001000
#820=0000000000
#821=0000000000
#990=0000008000
#991=0000051000
#992=0000061000
#893=0000000000
%
Good luck!