Hello group,
I am using a Taig CNC mill with Bobcad v20.7 software and Turbocnc. Please tell me if all cnc machines either large or small has this same problem since I haven't been around many cnc machines.
I am doing a 2d profile cut with arcs, circles and straight lines. Every time the machine finishes an arc, circle or straight line the machine stops briefly then starts on the next geometry and finishes that geometry and stops briefly.
Every time the machines stops for that brief moment it leaves a smaill but noticeable machine mark (indention on the part) where it has cut into the part from stopping.
Is this something that happens on all machines and controllers? Is there a way to have a smooth cut so I do not have to do any sanding afterward?
Thanks for any help!
Eric