586,100 active members*
2,604 visitors online*
Register for free
Login

Thread: NC 6600 ( version 6640 ) Philips

Results 1 to 2 of 2
  1. 05-15-2010, 02:45 PM #1
    vavco
    vavco is offline Member
    Join Date
    Mar 2008
    Posts
    29

    NC 6600 ( version 6640 ) Philips

    Hello to all of you ! Is there anybody among you there, who could help me with this old control system? Empty batteries have caused a loss of machine's parameters. Despite it , I have them written on the paper , I 'm not able to load them into RAM (by a hand) . Do not know where is the problem, have checked many electronics board, did not find any hardware problems. Thanks a lot for your time. Vlado
    Reply With Quote Reply With Quote
  2. 04-03-2012, 03:41 PM #2
    BehrElec
    BehrElec is offline Member
    Join Date
    May 2010
    Posts
    16

    NC6600

    I have work on these controls many years ago and remember that you had to enable the writing of machine parameters. On which type of machine is it used?

    Harald
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. powermax 45 machine version vs hand version
    By landmark in forum Hypertherm Plasma
    Replies: 1
    Last Post: 02-14-2010, 11:13 PM
  2. how to tranfer old version post to new version
    By ming035 in forum GibbsCAM
    Replies: 1
    Last Post: 02-11-2010, 08:08 PM
  3. philips
    By philips in forum UG NX
    Replies: 1
    Last Post: 06-30-2009, 08:27 PM
  4. Newest version of Mach3 Version 1.90.065
    By turmite in forum Mach Mill
    Replies: 3
    Last Post: 01-27-2009, 04:21 AM
  5. VCarve Pro Trial version 3.0: any newer version?
    By monte55 in forum Vectric
    Replies: 2
    Last Post: 12-12-2006, 12:12 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules