Originally Posted by
campaX
Hi,
I'll like to built a cnc pcb engraver.
will a cross slide table (like the one you see in the picture below) do the job for X/Y axis?
its only 9'' x 4'' of travel. but that will be fiine for me.
How hard will be to modificate this table to work with steppers?
has anybody done this before?
I already bought 3 steppers in ebay, 127oz-in of holding torque. what do you think about this motors?
I know electronics, so i will built my own controllers.
Thanks!
As long has the ways are tight and there is no backlash on the screws.
Aspire, VCPro, PhotoVCarve, Cut3D, Mach3, Home built CnC.